- MOTOROLA PROGRAMMING COMPUTER HOW TO
- MOTOROLA PROGRAMMING COMPUTER INSTALL
- MOTOROLA PROGRAMMING COMPUTER SERIAL
The above-mentioned criteria are applicable to Europe, the Middle East, and Africa. The policy is depending on the region you are using it. What cable s are you using?MotoTrbo CPS is the customer programming software who is needed to configure any MotoTrbo radio which is available to the Motorola channel partner. I using a computer with Windows Vista Business. I even tried reading the codeplug and got the same message. I need a little help I have followed all the steps up to the comm test. I have heard that turning the transceiver off and back on again power cycle just before attempting to initiate communication from the computer has helped, for some people. This is where you can change the frequencies, PL tones, offset, and time-out-timer.Ĭhange the settings to what you require.
MOTOROLA PROGRAMMING COMPUTER HOW TO
In this section, I will show you how to program frequencies, tones, offset, and the time-out-timer. If you get any error messages, double check everything above, and make sure all the settings are correct. This is where you will find out if your computer and your radio will be able to communicate. I was able to successfully program with a CPU Speed of up to cycles. We already discussed what cables worked for me. If you see this screen above, congratulate yourself! Now comes the part that just about everyone has trouble with. You should see a welcome screen that tells you to push any button, and then the following screen below. Your default text editor will open with the DOSBox conf file.
MOTOROLA PROGRAMMING COMPUTER INSTALL
If you have not done so yet, download and install the DOSBox program. If you have problems, change this back to the default setting. It will give you a warning that the port was opened by another application, and may have an unpredictable effect on the other application. This can be accomplished by checking the Device Manager.
MOTOROLA PROGRAMMING COMPUTER SERIAL
Note: If you have an existing serial port on your computer, just plug your Motorola RIB to the computer and the Motorola programming cable to the RIB and your transceiver. Fit furs goethe zertifikat a2įinally, attach the programming cable to the RIB and your transceiver. The first thing you need to do is get your hardware setup. I had to trash two different USB serial port adapters before I found one that worked for me. It is best to use the recommended cables and connectors listed above. There are other programming cables that may or may not work to program your Motorola Radius. I have received a few conformations from others that they do work as expected. Listed below are the recommended programming cables and connectors required to program the Motorola Radius. It will have nine pins and look like the picture.
![motorola programming computer motorola programming computer](https://i.ebayimg.com/images/g/g3UAAOSwccJcq6pl/s-l400.jpg)
If you have an older model computer, you are probably in luck. If you have a newer model computer, chances are that you do not have a serial port.
![motorola programming computer motorola programming computer](https://cdn.shopify.com/s/files/1/1757/2921/products/IMG_4795_clipped_rev_1_080955c2-2c50-4020-a2c2-cdfe71c6bfd5_1024x1024.jpg)
The cables and connectors required to program your Motorola Radius will vary from computer to computer. It took me about a week to figure out how to accomplish this dreadful task. Programming the Motorola Radius was not easy to learn.